Archive for category floor

Finishing that floor project

Here’s the thing about paint on floorboards (and probably other old wood surfaces) – it’s damn hard to take it off. Paint stripper, sanding, all of it only gets you so far. So, after a while, I agreed with the writing on the floor and decided to let sleeping metaphors lie. But the floor did need to be finished in some way, shape, and form (let’s be honest – the shape would probably be a slight rectangle) – the options were all some combination of painting and staining, or not, and laying some sort of urethane over the top, assuming I didn’t paint the entire floor.

While I didn’t love the oddly distressed look of the partially removed paint, it did have a certain style all its own. I finally decided to leave it as was, and leave the bare, sanded boards in the middle; a nice seal would show off their return to life.

CIMG8778 Read the rest of this entry »

No Comments

A quick transition

Removing the carpet from one room, but not the adjacent hallway, left a bit of a drop between the two:



I debated various possible home-brewed solutions, then stopped by Home Depot on the way back from something else and perused the floor transitions section. Turns out there’s something for just this sort of situation (it’s intended for tile adjoining carpet).



No Comments

Layers upon layers

An unexpected vacancy in one of my upstairs units prompted me to consider what more I could do with the space. The carpet was always more functional than anything else, so I decided to see what the floorboards underneath looked like and go from there.

Curiosity may have killed the cat, but here it just sent me down a rabbit hole of hard work, muffled curses, and occasional laughter at yet another roadblock. (Spoiler: it all ends well.) The previous owner’s recollection of what was under the carpet he’d laid was ‘the heaviest padding [he] could get’. Marvelous, I thought. Pull up the carpet and the padding, and the floorboards will be mine!

The carpet wasn’t tacked, just attached to tack strips on the edge. The padding underneath was… very, very thin, but perhaps, thought I, it was just pounded flat after years of use. And then I saw what was under the padding:


Five-eighths inch thick particle board. When you absolutely, positively
have to frustrate every [person] working on the project… accept no substitutes.

I debated stopping the project and shopping for new carpet instead, but decided to expose at least a little bit of the old floor. If it the original boards looked to be in good condition, it was probably worth proceeding. If there was laminate, or deeply scarred boards, or ugly knotted pine or something else, then carpet it would be.


Beneath the particle board seemed to be just a layer of tar paper, and then original, 100+-year-old nice, wide floorboards. The project would move forward…

… slowly. There were four full 4’x8′ sheets of particle board, several large sections, and a couple of smaller fills. Each was thoroughly nailed down:


So to recap: pull up the carpet, roll and remove; stuff 120+ square feet of padding into trash bags; pull a lot of staples from the particle board; pull all the nails from the boards; then lift and remove all these heavy boards (cutting up some water-damaged ones for disposal).


No, I don’t think I have too many tools, thankyouverymuch.

All the effort was, I think, well worth… the… effort. Aside from this one cracked board – the result of a window being left open during one or more storms years ago and water soaking into the particle board underneath a heavy cast-iron radiator – the old floorboards are in pretty good shape.




The floor – and quite likely the floors in the other upstairs rooms – were partly painted, a common decorating approach a century ago. A large area rug covered the center of the room and the floorboards were only painted around the rug. In this case, the room was redecorated at least once – a slightly different sized rug was used and a new color painted over most of the existing ‘frame’. You can still see the earlier brown color inside the orange that was used later.

The boards in the center were never finished in any way and have just grayed with time – they look to have interesting grain, and with their age they’ll be nice and hard regardless of the type of wood used. This’ll wind up looking good.



No Comments